ufs-0.3.1.1.s.tar.gz

This is the source for the Unix File System (ufs) for Linux kernels
1.3.x.  This version, 0.3.1.1, is able to mount NEXTSTEP filesystems
READ_ONLY from Linux. WRITING is not possible.

ufs-0.2 was developed by Yossi Gottlieb, 0.3nx by Bruno Haible
added support for NEXTSTEP filesystems (floppy and hard disk). This
version, 0.3.1.1, works for kernels >=1.3.x.

This is without any warranty. It works fine for me (kernel version
1.3.23, at the moment) with NEXTSTEP 3.2 and 3.3 partitions on two
SCSI disks.  There seem to be problems with symbolic links on UFS
filesystems.


REQUIREMENTS:

This patch should work with Linux kernel 1.3.x. For kernels 1.1
and 1.2, please use ufs-0.3-NeXT.


INSTALLATION:

unpack ufs-0.3.1.1.Linux.s.tar.gz in the directory _below_ your
Linux kernel source (e.g. /usr/src, if your kernel sources are in
/usr/source/linux). Then run the patch ufs-0.3.1.1.patch with 'patch
<ufs-0.3.1.1.patch'. Now you're ready to build your kernel from
scratch. You'll have to reconfigure the kernel and enable ufs
support. Hopefully a 'make dep;make clean;make config' followed by
'make' or so will do. If you're unsure about rebuilding and installing
a new kernel, please ask a Linux wizard.


USAGE:

After you've booted the new kernel with ufs support enabled, you
should be able to mount NEXTSTEP partitions with 'mount -t ufs
...'. Note that Linux has a different numbering scheme for the
partitions, you might check with fdisk.


Feel free to contact me if you have problems with the installation,
but don't expect to much help from me ;-)

	Gregor Hoffleit (flight@mathi.uni-heidelberg.de)